[ About ]
[ Batspeed Research ]
[ Swing Mechanics ]
[ Truisms and Fallacies ]
[ Discussion Board ]
[ Video ]
[ Other Resources ]
[ Contact Us ]
Re: Re: Re: Re: Bottom Hand Torque


Posted by: Jack Mankin (MrBatspeed@aol.com) on Thu Nov 25 18:18:19 2004


>>> The point is the hands do not torque the bat. <<<

Hi mb

Torque is also defined as “forces from opposing directions that cause an object to rotate about an axis.” – What are you thoughts on the post below from the Archives?



Re: Torque
Posted by: Jack Mankin (mrbatspeed@aol.com on Sat Oct 4 19:48:48 2003

>>> Hi Jack
Could you please explain how you came up with the 50/50 RE/torque scenario. Without being too scientific, what methods did you use? In a two handed situation, not one. <<<

Hi Enloe

There are two main forces acting on the bat to generate bat speed, torque and the transfer of the body’s rotational energy via a circular path of the hands. In order to isolate the bat speed developed from the CHP (Circular Hand Path) we added a steering-wheel knob to a 34-inch, 33 Oz. bat. Torque requires two forces being applied from opposing directions. The steering-wheel knob applies a single force at a single point on the bat. Therefore, all bat speed attained came from the CHP alone.

With the rotational swing, the hands travel around 22 to 24 inches from launch to contact. Following that hand-path with both hands on the steering-wheel knob we were able to attain bat speeds of 50 to 55 mph. (Note: Higher speeds were attained with one hand which allows a much longer CHP.)

We then isolated the torque factor by eliminating energy transferred by the CHP. This required holding the right hand at a fixed point and only applying torque to accelerate the bat-head. While the right hand was held at a fixed point, the bottom-hand rotated forward cocking the bat back about 90 degrees from contact (a heavy bag). Bottom-hand-torque (BHT) was applied as the lead-shoulder rotated back to the 105-degree position. This also produced speeds of 50 to 55 mph with no forward movement of the hands.

We concluded that with good rotational mechanics, about 50% of the bat speed came from the CHP and 50% came from torque. Pressure sensors placed on the handle of the bat support that conclusion. --- The 50/50 ratio does not hold true with more linear mechanics where as little as 10 to 15 mph is gained from the longer but straighter hand-path.

Jack Mankin


Followups:

Post a followup:
Name:
E-mail:
Subject:
Text:

Anti-Spambot Question:
This song is traditionally sung during the 7th inning stretch?
   All My Roudy Friends
   Take Me Out to the Ballgame
   I Wish I was in Dixie
   Hail to the Chief

   
[   SiteMap   ]